Trice-Brannon Holdings LLC, Waco, Texas 1-877-598-7223
|
SAVES TIME -
NO NEED TO REMOVE NUTPLATES OR SIMILAR HARDWARE
SAVES MONEY
- NO NEED FOR CLEAR PLASTIC TO MAKE TEMPLATES
SAVES TIME -
COPIES MULTIPLE HOLE PATTERNS NOT JUST ONE AT A TIME
SAVES MONEY -
REDUCES LOSS OF NEW PARTS FROM MISLOCATED HOLES
SAVES TIME -
NO NEED FOR CUTTING CLEAR MATERIALS FOR TEMPLATES
SAVES MONEY -
MAKES DUPLICATING HOLE PATTERNS FASTER AND EASIER
SAVES TIME -
REDUCES DISASSEMBLY TIME TO MAKE REPAIRS.
|
| How To Use The TracerMarker to duplicate hole patterns WITHOUT TEMPLATES |
CLICK ON PHOTOS TO ENLARGE
|
HOLE PATTERN TO BE COPIED
| CUT THE REQUIRED NUMBER OF
TRACERMARKERS FROM STRIP FOR
THE NUMBER OF HOLES TO BE COPIED.
| BEND ONE CORNER BACK TO
MAKE REMOVING PROTECTIVE
BACKING EASIER TO REMOVE.
|
THE CORRECT SIZE OF TRACERMARKER
SHOULD BE JUST SNUG ENOUGH THAT IT
WOULD NOT FALL OUT OF THE HOLE IF
TURNED UPSIDE DOWN.
| REMOVE PROTECTIVE BACKING FROM
TRACERMARKERS TO EXPOSE ADHESIVE.
IF TRACERMARKERS WILL NOT STAY IN
PLACE, WE RECOMMEND USING THE NEXT
LARGER DIAMETER TRACERMARKER.
| POSITION THE NEW PART TO BE
BE DRILLED WITH THE HOLE
PATTERN BEING COPIED.
|
WITH NEW PART POSITIONED OVER
TRACERMARKERS, APPLY HAND
PRESSURE TO ENSURE NEW PART
PICKS UP ADHESIVE TO PULL
TRACERMARKERS OUT OF THE HOLE.
| LIFT NEW PART FROM COMPONENT
BEING COPIED. TRACERMARKERS
WILL BE IN THE EXACT LOCATION
COPIED FROM ORIGINAL PATTERN.
| USE HAMMER TO INDENT EXACT
CENTERS OF NEW COMPONENT,
UTILIZING THE LOCATING FEATURE
OF THE TRACERMARKER. SMOOTH
JAW PLIERS OR SQUEEZE MAY
ALSO BE USED FOR THIS
OPERATION.
|
PEEL TRACERMARKER BACK
TO VERIFY HOLE CENTER HAS
BEEN INDENTED INTO THE NEW
PART BEFORE COMPLETELY
REMOVING TRACERMARKER.
| AFTER VERIFYING HOLE CENTERS
HAVE BEEN INDENTED,
TRACERMARKERS MAY NOW BE
REMOVED AND HOLES CAN BE
DRILLED UP TO SIZE.
|
|
|
